Mitsubishi Electric FR-F700PJ Series, Инструкция по эксплуатации

Страница: 72 / 356

59
Operation panel
P
ARAM
ETE
R
S
4
4.1.2 Basic operation (factory setting)
Hz
A
STOP
Operation mode switchover
Parameter setting
Faults history
Monitor/frequency setting
At power-ON (External operation mode)
PU operation mode
(output frequency monitor)
Parameter setting mode
PU Jog operation mode
Output current monitor
General-purpose
motor control
Set frequency
is displayed
Output voltage monitor
Display the
present setting
Value change
Keep pressing
the setting dial
Parameter write is completed!!
Parameter and a setting value
flicker alternately.
Parameter clear
Automatic
parameter setting
IPM parameter
initialization
All parameter
clear
Faults history clear
Initial value
change list
(Example)
(Example)
(After 1s)
Frequency setting has been
written and completed!!
and frequency flicker alternately.
[Operation for displaying faults history]
The past eight faults can be displayed using the setting dial.
(The latest fault is ended by ".".)
When no fault history exists, is displayed.
While a fault is displayed:
The display shifts as follows by pressing : Output frequency at the fault
Output current Output voltage Energization time.
(After Energization time, it goes back to a fault display.)
Pressing the setting dial shows the fault history number.
Value change
(Refer to page 297)
(Refer to page 61)