Mitsubishi Electric FR-F700PJ Series, Инструкция по эксплуатации

Страница: 115 / 356

110
Frequency setting by external terminals
4.7.3 Remote setting function (Pr. 59)
The above parameter can be set when Pr. 160 Extended function display selection = "0" . (Refer to page 156)
* External running frequency (other than multi-speed) or PU running frequency
NOTE
 The Pr. 15 setting should be equal to or higher than the Pr. 13 Starting frequency.
 Changing the terminal assignment using Pr.178 to Pr.182 (input terminal function selection) may affect other functions. Set
parameters after confirming the function of each terminal.
 During Jog operation, the second acceleration/deceleration via the RT signal cannot be selected. (The other second
functions are valid. (Refer to page 137) )
 When Pr. 79 Operation mode selection = "4", pressing of the operation panel and
/
of the parameter unit
(FR-PU04/FR-PU07) starts the inverter and pressing stops the inverter.
 This function is invalid when Pr. 79 = "3".
Parameters referred to

Pr. 13 Starting frequency Refer to page 116

Pr. 20 Acceleration/deceleration reference frequency, Pr. 21 Acceleration/deceleration time increments Refer to page 113
 Pr. 79 Operation mode selection Refer to page 200
 Pr. 178 to Pr. 182 (input terminal function selection) Refer to page 134
 Even if the operation panel is located away from the enclosure, you can use contact signals to perform continuous
variable-speed operation, without using analog signals.
 By merely setting this parameter, you can use the acceleration, deceleration and setting clear functions of the
remote speed setter (FR-FK).
Parameter
Number
Name Initial Value
Setting
Range
Description
RH, RM, RL signal
function
Frequency setting
storage function
59 Remote function selection
0
0 Multi-speed setting —
1 Remote setting With
2 Remote setting Not used
3 Remote setting
Not used
(Turning STF/STR OFF
clears remotely-set
frequency.)
Forward rotation
Acceleration
Deceleration
Clear
Inverter
Connection diagram
for remote setting
STF
RH
RM
RL
SD
10
2
5
0
ON ON ON
ON
ON
ON ON ON ON
ON ON
Deceleration
(RM)
Clear (RL)
Acceleration
(RH)
Forward rotation
(STF)
Power supply
0Hz
Time
Output frequency (Hz)
∗
When Pr. 59 = 1
When Pr. 59 = 2, 3
When
Pr. 59
= 1, 2
When Pr. 59 = 3