Mitsubishi Electric FR-D720-0.2K-G, Инструкция по эксплуатации

Страница: 72 / 302

Parameter list Parameter list
68
4
P
ARAME
TERS
Parameter List
—

Pr.CH
Initial value change list — — — 248

Pr.CH
— — — — — —
— 
PM
PM parameter initialization 6004, 8009, 9009
*8
1 6004 73 
PM
— F4 — — — —
— 
AUTO
Automatic parameter setting — — —
239

AUTO
— — — — — —

Differ according to capacities. (2.2K or lower/3.7K)

The initial value differs according to the voltage class. (200V class/400V class)

The parameter number in parentheses is the one for use with the parameter unit (FR-PU07).

Write is disabled in the communication mode (Network operation mode) from the PU connector.

These parameters are communication parameters that are not cleared when parameter clear (all clear) is executed from RS-485 communication. ( Refer to
page 184
for RS-485 communication.)

The capacity of the S-PM geared motor is initially set to the next smaller size than the capacity of the drive unit.

While the parameter settings copied to the latest version drive unit (manufactured in April 2018 or later) are verified against the parameter settings copied
to the parameter unit (FR-PU07) from the older version drive unit (manufactured in March 2018 or earlier) after the parameter settings are copied, a
verification error about parameters marked with

7 will be displayed. However, these errors are not faults.
Press "0" on the parameter unit to proceed the verification. (For information about Parameter copy and Parameter verification, refer to the Instruction
Manual of the parameter unit.)
Copying the parameter settings from the latest version drive unit to the older version drive unit is prohibited. If doing so, reset the copied parameter
settings by performing Parameter clear or All parameter clear.

Settings "8009" and "9009" can be displayed after offline auto tuning is performed.
REMARKS
 The unit for parameter setting and its setting range can be changed from "r/min" to "Hz". Use Pr. 144 to change the setting.
 With operation panel, the value up to 9999 can be set. With parameter unit (FR-PU07), up to the highest value in the setting
range can be set.
 If a value exceeding the upper speed limit of the motor is set, the actual operation will be limited at the maximum rotation
speed.
Function
Parameter Name Setting Range
Minimum
Setting
Increments
Initial
Value
Refer
to
Page
Customer
Setting
Parameter Remarks
Instruction Code Parameter
Read Write Extended Copy Clear All Clear