Mitsubishi Electric FR-CC2-P, Инструкция по эксплуатации

Страница: 75 / 184

Operation panel
74
BASIC OPERATION
4.1
Operation panel
4.1.1
Components of the operation panel
Install the operation panel of the inverter on the converter unit.
To mount the operation panel on the enclosure surface, refer to
page 55 .
No. Component Name Description
(a)
— Not used.
(b)
Operation panel
status indicator
MON: ON to indicate the monitor mode. Quickly blinks twice intermittently while the
protective function is activated.
Slowly blinks in the display-off mode.
PRM: ON to indicate the parameter setting mode.
(c)
— Not used.
(d)
— Not used.
(e)
Monitor (5-digit LED)
Shows the monitored status, parameter number, etc.
(Using
Pr.774 to Pr.776 , the monitored item can be changed.)
(f)
— Not used.
(g)
— Not used.
(h)
STOP/RESET key Resets the converter unit when the protective function is activated.
(i)
Setting dial
Changes the parameter settings.
Press the setting dial to perform the following operations:
 To display a monitored item set in Pr.992
 To display a fault history number in the fault history mode
(j)
MODE key
Switches to different modes.
Holding this key for 2 seconds locks the operation. The key lock is invalid when
Pr.161
= "0" (initial setting). (Refer to page 90 .)
(k)
SET key
Enters each setting.
If pressed during the operation, monitored item changes as the following:
(Using
Pr.774 to Pr.776 , the monitored item can be changed.)
(l)
ESC key
Goes back to the previous display.
Holding this key for a long time changes the mode back to the monitor mode.
(m)
— Not used.
(a) (b) (c)
(d)
(e)
(g)
(f)
(h)
(i)
(j)
(k)
(l)
(m)
Converter
output voltage
When the initial setting is set
Input
current
Electric thermal relay
function load factor