Mitsubishi Electric FR-A8ND, Инструкция по эксплуатации

Страница: 82 / 104

OBJECT MAP
81
7
7.2.8 Class 0x66 (Extended object I)

Class 0x66 Instance 1
Set parameters of the inverter. The data type of each attribute is UINT, and the size is 2 bytes.
The usable parameters depend on the inverter. Refer to the Instruction Manual (Detailed) of the inverter for details of the
parameters.
NOTE
• For parameter writing or reading, Class 0x70 to 0x79 (Extended object III) is recommended. (Refer to page 90 )
[Attribute]
Class 0x66 Instance 1
Attribute
ID
Pr. Access Name
10 Pr.0 Get/Set Torque boost
11 Pr.1 Get/Set Maximum frequency
12 Pr.2 Get/Set Minimum frequency
13 Pr.3 Get/Set Base frequency
14 Pr.4 Get/Set Multi-speed setting (high speed)
15 Pr.5 Get/Set Multi-speed setting (middle speed)
16 Pr.6 Get/Set Multi-speed setting (low speed)
17 Pr.7 Get/Set Acceleration time
18 Pr.8 Get/Set Deceleration time
19 Pr.9 Get/Set Electronic thermal O/L relay
20 Pr.10 Get/Set
DC injection brake operation
frequency
21 Pr.11 Get/Set DC injection brake operation time
22 Pr.12 Get/Set
DC injection brake operation
voltage
23 Pr.13 Get/Set Starting frequency
24 Pr.14 Get/Set Load pattern selection
25 Pr.15 Get/Set Jog frequency
26 Pr.16 Get/Set Jog acceleration/deceleration time
27 Pr.17 Get/Set MRS input selection
28 Pr.18 Get/Set High speed maximum frequency
29 Pr.19 Get/Set Base frequency voltage
30 Pr.20 Get/Set
Acceleration/deceleration reference
frequency
31 Pr.21 Get/Set
Acceleration/deceleration time
increments
32 Pr.22 Get/Set
Stall prevention operation level
(Torque limit level)
33 Pr.23 Get/Set
Stall prevention operation level
compensation factor at double
speed
Class 0x66 Instance 1
Attribute
ID
Pr. Access Name