Mitsubishi Electric EW-50A, Инструкция по установке и эксплуатации

Страница: 34 / 80

34
WT07936X05
10-3-1. Preparation
Follow the instructions below to change the IP address of the PC that is used for software update.
Note: When the system is connected to the existing LAN, ask the system administrator for permission before changing the
IP address settings and updating the software.
(1) Click [Control Panel] in the Start menu, and click [Network and
Sharing Center]>[Local Area Connection].
In the [Local Area Connection Status] window, click [Properties].
(2) Click [Internet Protocol Version 4 (TCP/IPv4)] to select it, and click
[Properties].
(3) In the [Internet Protocol Version 4 (TCP/IPv4) Properties] window,
check the radio button next to [Use the following IP address].
Enter [192.168.1.*] in the [IP address] field. (The number indicated
with an asterisk must be different from the IP address of the EW-50 to
be updated.)
Leave [255.255.255.0] in the [Subnet mask] field as it is.
Note: If the IP address of the EW-50 is [192.168.1.1], set the same 1st, 2nd, and 3rd
numbers and different 4th number, such as [192.168.1.2].
Note: Default IP address of EW-50 is [192.168.1.1].
Note: When performing an update on a PC that is already connected to the existing
LAN, [255.255.255.0] may not appear in the [Subnet mask] field. When
[255.255.0.0] appears, enter the same 1st and 2nd numbers (192.168) and
different 3rd or 4th number of the IP address of the EW-50 in the [IP address]
field.