Mitsubishi Electric 800 Series, Инструкция по эксплуатации, Страница: 57 / 727

Communication connectors and terminals
56
INSTALLATION AND WIRING
2.7
Communication connectors and terminals
2.7.1
PU connector
 Removal and reinstallation of the accessory cover
 Mounting the operation panel on the enclosure surface
• The operation panel can be used for setting the inverter parameters, monitoring various items, and checking fault
indications.
• Having an operation panel on the enclosure surface is convenient. With a connection cable, the operation panel can be
mounted to the enclosure surface and connected to the inverter.
Use the option FR-CB2[ ], or connectors and cables available on the market.
(To mount the operation panel, the optional connector (FR-ADP) is required.)
Securely insert one end of the connection cable until the stoppers are fixed.
• Loosen the two screws on the accessory cover.
(These screws cannot be removed.)
• Press the upper edge of the accessory cover while pulling
out the accessory cover.
To install the accessory cover, fit it securely and tighten the screws. (Tightening torque: 0.40 to 0.45 N·m)
Loosen Loosen
Parameter unit connection cable
(FR-CB2[ ]) (option)
Operation panel (FR-LU08)
Operation panel connection connector
(FR-ADP) (option)