Mitsubishi Electric 13JV28, Справочное руководство

Страница: 76 / 378

74
4 CC-Link
4.5 Backing up/Restoring Data of Devices Supporting iQSS
Data backup
Information of a device supporting iQSS can be saved in an SD memory card for each station by using an engineering tool.
Operating procedure
The initial values of the backup setting (SD1438 and SD1444) are as follows:
• SD1438 (Folder number setting): FFFFH (automatic specification)
• Lower 8 bits of SD1444 (operation setting on error): 0H (continue)
Use a program when backing up data with the settings other than the one above. (

Page 75 Program
execution for data backup)
■
Other methods of data backup
Data can be backed up by the following methods.
• Select a target module in the 'List of stations' or 'Device map area' in the "CC-Link Configuration" window, then right-click
and select [Backup Slave Station] from the shortcut menu.
• Select a target module in the 'List of stations' or 'Device map area' on the "Sensor/Device Monitor for CC-Link" screen, then
right-click and select [Backup Slave Station] from the shortcut menu.
■ Execution method of data backup for a device supporting iQSS which is connected to a
bridge module (NZ2AW1C2AL)
Data can be backed up for a device supporting iQSS, which is connected to a bridge module (NZ2AW1C2AL), by the
following method.
Operating procedure
1.
Select a bridge module (NZ2AW1C2AL) in 'List of stations' or 'Device map area' in the "CC-Link Configuration" window.
2.
Select [CC-Link Configuration]  [Open System Configuration]  [Open AnyWireASLINK Configuration].
3.
Select [AnyWireASLINK Configuration]  [Online]  [Backup Slave Module] in the "AnyWireASLINK Configuration"
window.
1.
Select a target device supporting iQSS in 'List of stations' or
'Device map area' in the "CC-Link Configuration" window, and
select [CC-Link Configuration]
 [Online]  [Backup Slave
Station].
2.
Read the message, and click the [Yes] or [OK] button.
Data is backed up.
2. Select
1. Select