Mitel UC360, Руководство администратора

Страница: 33 / 141

UC360 Configuration
17
Network Settings
If installing the UC360 with a MCD, it may be easier to use static VLAN and QoS values by
manually entering the information into the UC360 Network Settings menu rather than obtaining
parameters via DHCP or other methods.
However, if you choose to have a DHCP server provide these values to the UC360, it should
be noted that the MCD DHCP server may not support a field for defining L2 and L3 QoS values
for Multimedia Conferencing. In this case, the L2 and L3 QoS values for Multimedia
Conferencing will need to be statically programmed.
Where possible, the DHCP values are displayed below the entry.
DHCP (value) - This indicates the value was not programed by the administrator and was
obtained via DHCP from the network. Static values programmed by the administrator don't have
this encapsulation.
For example:
Default Gateway IP Address
DHCP (10.33.36.171)
The Default Gateway IP Address is obtained from the DHCP server and the value is shown in
parentheses.
Static values programmed by the administrator are not shown in parentheses.
Software HTTP Server Address
10.00.00.00
Note: The UC360 does not support the Windows 2000 server for DHCP.
1. Press Settings .
2. Press Advanced.
3. Press System Settings.
4. Press Network Settings.
The following options are available as listed below.
View Current
All the items below are initially retrieved from the DHCP, except the MAC address. Some of
these options may be overridden by the Static settings.
SIP Server
The IP address (IPv4) or the FQDN format address of the SIP server.