Mitel UC360, Руководство администратора

Страница: 29 / 141

UC360 Configuration
13
Prerequisites
• Before configuring SIP settings, ensure that MCD programming or 5000 CP programming
is completed. See “Programming MCD for the UC360” on page 63 or “5000 CP Configu-
ration for the UC360” on page 75.
• Obtain the SIP Server address name, User Name, and Login Name from the User and
Device Configuration form.
• For MiVoice Border Gateway specific settings, see “UC360 Used as Teleworker” on
page 56.
1. Press Settings .
2. Press Advanced.
3. Press System Settings.
4. Press SIP Settings.
Account
Under Account , set the following parameters:
1. Enter the Server Address — the IP address (IPv4) or the FQDN format address of the SIP
server.
2. Enter the Username — the SIP user’s ID. It is typically the DN (extension number) assigned
on the SIP server.
Authentication
Under Authentication
1. Enter the login name — typically the DN.
2. Enter the password — typically the DN.
Transport
Three transport types are supported:
• TLS — enable TLS secure protocol
• TCP — enable/disable TCP protocol
• UDP — enable/disable UDP protocol
Only the selected (check box) transport types will be connected if they are available on the
server.
The connection order is based on the order of checked transports (top to bottom) (TLS, TCP,
UDP). If a higher priority transport is not available, the next higher in priority order will be
used. The successfully connected transport will be indicated with a *.