Technician’s Handbook
92
NOTE: 1.
Be aware of the difference between the code “E” and the code “E.”. “E” indi-
cates MCC error and “E.” indicates disk drive errors.
2.
If system is restarted at this point, the pending logs will be lost.
Table 14: Floppy Disk Drive Error Code Summary
Error
Code
Likely Cause(s)
E.
1
Original system diskette has been replaced, and logs are pending.
Either re-insert original diskette, or restart system. See Note 2.
E.
2
Original system diskette has been replaced. Either re-insert original
diskette, or restart system. See Note 2.
E.
3
Disk drive is empty, and disk updates are pending. Either re-insert
original diskette, or restart system. Disks may be locked (try
backups). See Note 2.
E.
4
Disk drive is empty. Either re-insert original diskette, or restart
system. See Note 2.
E.
5
There is an obstruction over the diskette “write notch” (a
write-protect sticker) - remove it, or on a 31/2” disk, slide protector
over the hole.
E.
6
Diskettes A and B don’t match (are not of the same load) - insert
proper diskettes and restart system.
E.
7
Restart system. If this persists, assume faulty Main Control - refer to
the Main Control procedures.
E.
8
Decryption Module is missing - install correct module, and restart
system. If this persists, assume faulty Main Control - refer to the
Main Control procedures.
E.
F
Information cannot be accessed on disks. Either re-insert
diskette, or restart system.
Содержание SX-200 EL
