Mitel SmarT-1 EuroRoute, Инструкция по установке и программированию

Страница: 60 / 128

Line and Trunk Options
8350-383-113-BA
59 Draft 1A, September 1998
8. 24. S26 - Interdigit Timer for Buffer C
This register sets the time the caller has to enter each digit after the first digit has been dialled,
while screening in Buffer C. (Buffer C Represents the second cost centre code buffer).
Note: If you are using a terminal you can substitute the letter A for
✳
and B for #.
8. 25. S27 - Default Route
If an interdigit timer expires before a route is completely specified, the EuroRoute forces the
call on to a pre-selected route or returns Number Unobtainable tone.
† NU Tone = Number Unobtainable Tone.
8. 26. S28 - Route to use for Operator (100-) Calls
When the operator code is matched with no other digits dialled this register specifies the route
to be used.
† NU Tone = Number Unobtainable Tone.
Port Register Default Description
1
2
3
4 126 T
226 T
326 T
426 T 3
3
3
3 T = 0 For No Time-out
T = 1 For 1 Sec T = 9 For 9 Secs
T = 2 For 2 Secs T =
✳
For 10 Secs
T = 3 For 3 Secs T = # For 11 Secs
T = 4 For 4 Secs T = C For 12 Secs
T = 5 For 5 Secs T = D For 13 Secs
T = 6 For 6 Secs T = E For 14 Secs
T = 7 For 7 Secs T = F For 15 Secs
T = 8 For 8 Secs
To change all Ports to the same value use 526 T.
Port Register Default Description
1
2
3
4 127 T
227 T
327 T
427 T 9
9
9
9 T = 1 For Route 1 T = 6 For Route 6
T = 2 For Route 2 T = 7 For Route 7
T = 3 For Route 3 T = 8 For Route 8
T = 4 For Route 4 T = 9 For NU Tone †
T = 5 For Route 5
To change all Ports to the same value use 527 T.
Port Register Default Description
1
2
3
4 128 T
228 T
328 T
428 T 1
1
1
1 T = 1 For Route 1 T = 6 For Route 6
T = 2 For Route 2 T = 7 For Route 7
T = 3 For Route 3 T = 8 For Route 8
T = 4 For Route 4 T = 9 For NU Tone †
T = 5 For Route 5
To change all Ports to the same value use 528 T.