Operation and Maintenance
229
Mitel SMB Controller
syd-0657/2.0 – R6.0 – 09.2018
Example:
Power output: There are no serious or critical event messages. The communication
server line in the SRM agent is blue and the system status is on
Normal
.
1. The event message
Charge counter overflow
reaches the SRM server.
→
The communication server's system status in the SRM agent changes to
Serious
,
and the destinations turn yellow.
2. The event message
Fan failure
reaches the SRM server.
→
The communication server's system status in the SRM agent changes to
Critical
,
and the destinations turn red.
3. The event message
Charge counter overflow
is confirmed in WebAdmin in the
Ac-
tive event messages view
(
=mr
).
→
The system status of the communication server in the SRM agent remains on
Critical
, and the destinations on red, because there is still an event message with
this severity.
4. The event message
Fan failure
reaches the SRM server.
→
The communication server's system status in the SRM agent changes to
Normal
,
and the destinations turn red.
After a first-start of the communication server, the
SRM destination
is automatically al-
located event table 7. The notification service to the SRM destination can be switched
on or off.
On the SRM server the status modification per communication server must be allowed
and configurations are also required in WebAdmin. You can find a configuration guide
in WebAdmin help under the
Message destinations
=h1
view.
Testing the signal destination configuration
To test the configuration, a test event message can be separately initiated for each
destination in the WebAdmin configuration (
Message destinations
=h1
view). The
event message is signalled without any delay, directly at the selected signal destina-
tion.
If the communication server is connected via a modem or terminal adapter, the test
event messages will be signalled only once the connection is cleared down.
6. 5. 2
Operating state and error displays
6. 5. 2. 1
System operating state
During the start-up phase, various self-tests are performed and the individual phases
are shown in the LED display on the front panel (see "Start-up mode", page 198).
