Mitel MIVOICE OFFICE 250, Руководство по установке и администрированию

Страница: 550 / 585

MiVoice Office 250 Installation and Administration Guide
522
0, the secondary phone never receives the burst of ringing. During keymap programming, the
option is programmed individually for each secondary extension button.
• Transient Call Indication On Call Answer : Determines if the phone user sees a call display
when answering a call by pressing the secondary extension button or reverse-transferring the
call. If enabled, the display indicates if the call was ringing, recalling, transferred, or holding at
the primary phone.
The secondary extension button can be located on the phone. There are two ways to make a
secondary extension button:
• Create a secondary extension button in the keymap and determine which phone it will represent.
This will be the same for all phones assigned to that keymap.
• Set the default value of a user-programmable button to “secondary extension key” in the keymap.
This allows each phone user assigned to that keymap to determine the associated phone for
his or her secondary extension button.
User-programmable buttons cannot be made into secondary extension buttons by the phone user;
they can only be created in the database. Also, the phone user cannot change the button into any
other
type
of button (such as a Speed Dial or feature button), even though it is assigned to a
user-programmable button.
Any phone button can be designated as a secondary extension button, but buttons with lamps are
recommended so that the secondary extension button can show call status. For flash rate definitions,
refer to “Specifications” chapter in the
MiVoice Office 250 Installation Manual
.
The secondary extension button shows only calls that appear under the CALL buttons at the primary
phone. Any calls on individual trunk buttons at the primary phone are considered private calls and
will not appear on the secondary extension button.
Normally, the secondary extension button will not show intercom calls. However, if the primary phone
does not have an IC button, intercom calls will appear under a CALL button and, therefore, will
appear on the secondary extension button. If the primary phone is a single line phone,
all
calls will
appear on the secondary extension button.
After answering a call on the secondary extension button, the phone user can transfer it back to the
primary phone using one of the following methods:
•
Transfer to hold : Press the secondary extension button, announce the call, if desired, and then
hang up.
• Transfer to ring : Press TRANSFER and then the secondary extension button. You can an -
nounce the call, if desired, before hanging up to complete the transfer.
Because the calls that appear on the secondary extension button are active only at the primary
phone, they will not follow call forwarding or system forwarding paths at the phone with the secondary
extension button.
Phone LED Indications
Phone CALL buttons, trunk buttons, Speed Dial buttons, hunt group buttons, and some of the feature
buttons contain light-emitting diodes (LED). LED flash rates indicate the status of the phones, trunks,