Mitel MIVOICE OFFICE 250, Руководство по установке и администрированию

Страница: 214 / 585

MiVoice Office 250 Installation and Administration Guide
186
6. If not adding any other modules, continue to “Installing the USB Security Key and Compact
Flash-Type Memory Card” on page 150. Otherwise, continue to “Installing a Two-Port Loop Start
Module (LSM-2)” on page 1-189 .
To remove a PM-1:
1. Use the LCD panel on the front of the chassis to shut down the system.
2. Unplug the chassis power cord from the power source.
3. Loosen the fastener at the top of the module (this fastener secures the module to the chassis).
4. Using a properly terminated, anti-static wrist strap, remove the module from the chassis and
place it into the anti-static bag that came with the module.
Adding a Processor Expansion Card (PEC-1)
An optional Processor Expansion Card (PEC-1) provides additional IP resources. See the
Specifications and Product Description chapters for PEC-1 details. The PEC-1 includes the
necessary hardware to mount it to the PM-1.
To install the PEC-1 on a CS Controller PM-1:
1. Perform a Database backup using DB Programming. You can also back up the database using
the LCD panel. For details, refer to the
MiVoice Office 250 Features and Programming Guide
.
2. Perform a voice mail backup using a USB flash drive attached to the USB-A port on the front
of the CS Controller. Do not back up VM to the compact flash-type memory card. Refer to the
MiVoice Office 250 Features and Programming Guide
, for details on backup up either Unified
Voice Messaging or external voice mail.
3. Shut down the system using the LCD panel. See Figure 4 on
page 169
for an illustration of the
menu locations. Unplug the chassis power cord.
4. Wearing a properly terminated anti-static wrist strap, loosen the fastener at the top of the PM-1.
Remove the PM-1 from the chassis and place it on a clean, ESD-protective, surface.
5. Using Figure 3 on
page 188
as a guide, do the following:
a. On the PM-1, remove the strap across the first seven pins on the mount point closest to the
front of the chassis. Do not discard the strap. Please read the important message below.
NOTICE
Equipment Damage Hazard . Use the LCD panel to shut down the system, and unplug all power
sources to the chassis before working with the PM-1. Replacing or inserting a PM-1 with AC power
turned on to the chassis will damage the PM-1. A PM-1 damaged in this manner will not be replaced
under warranty
.
Electrostatic Discharge (ESD) . The modules and components are static-sensitive. When working
with the modules, use a properly terminated anti-static wrist strap. Any static charge (no matter how
small) must be discharged from the body before touching the modules or other components.
The
warranty for this equipment does not cover damage caused by static or mishandling. Modules or
components damaged in such a manner will not be replaced.