Mitel MIVOICE OFFICE 250, Руководство по установке и администрированию

Страница: 117 / 585

Specifications
89
The ports provide full I.430 ITU S/T ISDN support for trunks (TE mode), but does not support stations
(NT) mode. The BRM-2 does not support video conferencing or BRI devices and phones.
16-Port Digital Desktop Module (DDM-16)
Up to 16 digital devices can be connected to the DDM-16, and there can be up to three DDM-16s
installed in any of the four HX Controller expansion bays. The same digital telephones and SLAs
supported on the DEI’s DEM-16 are supported on the DDM-16. Each DDM-16 includes:
• A single 48-pin connector and a special DDM cable for connection to a station block at the Main
Distribution Frame
• Status LEDs (online, busy, and remove)
• Module release lever for safely removing the module from the bay
• DSP resources (4 DTMF receivers, 5 tone generators, and 16 speakerphones for devices con
-
nected to the module)
Four-Port Single Line Module Characteristics
Up to four SLM-4s can be installed in the HX Controller chassis, but only one SLM-4 can be installed
in the CS Controller chassis.
The Single Line (SL) application installs as a part of the MiVoice Office 250 Version–Release suite
of software packages, along with other application packages that support SLM-4 functionality, such
as DB Programming, Call Processing, etc. The SLM-4:
• Is hot-swappable.
• Is designed to be inserted into one of the available bays on the back side of the Mitel 5000. The
form factor used for the SLM-4 is the same as used for the T1M or T1M-2, LSM-2, LSM-4, and
BRM-2 modules.
• Supports two green status LEDs. One shows
ONLINE
status, and the other shows the ready to
REMOVE
status. The SLM-4 provides two RJ-14 jacks, each wired to USOC T568A specifica -
tions. Together, the two jacks support four single line analog phones.
• Does
not
require software feature licensing.
• Does not operate on a v1.x system. If you plug an SLM-4 into a v1.x system, a warning message
appears and Message Print indicates the board will not come online.
• Does not support dial pulse dialing.
• Does
not
respond to the Auto Equip feature—SLM-4 modules must be programmed manually
in DB Programming. For instructions, refer to the
MiVoice Office 250 Features and Programming
Guide
.
NOTE
This module functions only in the HX Controller chassis. Do
not
attempt to install it in the CS
Controller chassis, as damage may occur. Also, DDM-16s are not subject to any of the voice
channel trade-offs that the DEM-16s are subject to when used in two-DEI or four-DEI mode.