mvip@mitech-ndt.com
Note: For saving power, lower down the LCD brightness in good light environment.
5.14 Display Standby Setting
Standby state lower down the LCD brightness and puts the CPU in a power conserving mode.
The change from run state to standby state is controlled by the setting of the Display standby
delay.
See right figure of Display
Standby Delay dialog box
for the items of the settings.
Press arrow keys or F2 key
to select the desired item.
Selecting “Disable” item will
forbid
the
main
unit
switching into standby state.
The main unit goes into standby state after a period of time as selected. Carry out a test or
press any key to reactivate the main unit from standby state.
5.15 Auto Poweroff Setting
The change from standby state to power off state is controlled by the setting of automatic
shutdown delay.
The time delay can be
configured by the user in the
auto shutdown delay dialog
box.
Press arrow keys or F2
key to select the desired item.
Selecting “Disable” item
will forbid the main unit
switching automatically into
power off state.
Note: If the voltage of the battery is too low, the LCD screen will show “Battery Exhausted!”,
then power off automatically.
5.16 Changing Unit System
The instrument supports
both metric and imperial unit
systems.
In
the
System
Configuration dialog, press
on the Unit System item
to switch back and forth
between imperial and metric
unit system.
5.17 Date and Time setting
For a correct documentation you should always make sure that you are using the correct date
and time setting. Open the system time dialog to set date and time of the instrument system.
The format for date: Year-Month-Date
The format for time: Hour–Minute- Second