iMistAway Setup Guide
Verify iMistAway Kit Contents
Step Two – Mount iMistAway Node on Misting Unit
A7:D3
iMistAway
Gateway
iMistAway Node
Antenna (Gen 1.3)
Ethernet Cable
and Power
Adapter
Step One – Install Gateway Unit
Gen 3 Antenna Kit.
Contains 1 antenna, 1 antenna cable
and 2 mounting nuts (not pictured)
Gen 1.3 Mounting Location
Gen 3 Mounting Location
Gen 1.3 (Tank Unit)
Connect the Gateway Unit to your customer’s Internet router or modem
using the included CAT-5 cable.
Connect your iMistAway Gateway Unit to the power adapter.
Place the gateway in a position which is as elevated as possible and not in
a metal cabinet – this will help to maximize wireless signal strength.
When the Gateway Unit is connected to the iMistAway server, the
“globe” symbol ( ) will be lit up with a solid green light.
Record the MAC Address and PAN ID on the Gateway Unit label.
Thread antenna onto iMistAway Node.
Mount node inside unit, next to the remote receiver. The Node antenna
should point away from the remote reciever. The Node ships with red
mounting tape attached.
Mount iMistAway Node to underside of lid. Use the two nuts supplied in
the Antenna Kit to secure the iMistAway Node to the lid.
Connect supplied antenna cable to male connector on iMistAway Node
Push the male connector end of the supplied antenna cable through hole
in lid of misting unit. Secure cable using attached nut, washer and o-ring.
IMPORTANT -
O-Ring on antenna cable must be placed on the top of the lid before
securing the cable using the attached nut.
Thread iMistAway antenna onto the antenna connector.
A
B
C
D
E
A
B
A
B
C
Gen 3 (Tankless Unit)
D
