Elevator Restriction System Installation and Operation Manual
5
1
Introduction
This manual provides information about the installation and operation of the
TX3 Elevator Restriction System, and must be read in its entirety before
beginning any installation work.
Installation must be performed by a qualified technician and must adhere to the
standards and special notices set by the local regulatory bodies.
Note:
Mircom periodically updates panel firmware and Configurator
Software to add features and correct any minor inconsistencies. For
information about the latest firmware or software visit the Mircom
website at
www.mircom.com
.
Warning: The Telephone Access System assembly must be grounded by a
qualified electrician. An improperly grounded unit can result in
equipment malfunction and electrical shock.
This manual explains
•
Elevator Restriction Unit Installation and Operation
1.1
Firmware Versions
Note:
For instructions on upgrading firmware see LT-995 TX3 System
Configuration and Administration Manual.
TX3 panels run either version 2 firmware or version 3 firmware, depending on
their hardware.
•
If your panels run version 2 firmware, you must upgrade to version 2.4.x
or higher in order to use floor groups.
•
If your panels run version 3 firmware, you must upgrade to version 3.4.x
or higher in order to use floor groups.
•
If you do not upgrade your panels to version 2.4.x or 3.4.x, you can still use
elevator restriction but you cannot use floor groups.
If you have TX3-ER-8-B (ERU 2.0), see LT-995 TX3 System Configuration and
Administration Manual for firmware compatibility.
