Mirapoint RazorSafe 170, Руководство по оборудованию

Страница: 31 / 76

Optical Drive
31
Optical Drive
A slimline
DVD
optical drive slides into the front panel and connects to the SATA
controller on the system-board.
n
DVD devices are data only.
Removing an Optical Drive
c
Only trained service technicians are authorized to remove the appliance cover and
access any of the components inside the appliance. Before you begin this procedure,
review the safety instructions that came with the appliance.
To remove an optical drive:
1. If installed, remove the optional front bezel. See Removing the Front Bezel on
page 29.
2.
Power off the appliance, including any attached peripherals, and disconnect the
appliance from its electrical outlet.
3. Open the appliance. See Opening the Appliance on page 30.
4.
Pull the blue pull tab on the data cable to disconnect it from the back of the
drive and the system-board.
5. Disconnect the power and data cables from the back of the drive.
Note the routing of the power and data cables underneath the tabs on the
appliance chassis as you remove them from the system-board and drive. You
must route these cables properly when you replace them to prevent them from
being pinched or crimped.
6. Press down the release latch. Lift and angle the drive to release it from the notch
on the metal standoffs.
7. Lift the drive out of the chassis ( Figure 7 on page 32).
8. Close the appliance. See Closing the Appliance on page 30.
9. If applicable, replace the optional front bezel. See Installing the Front Bezel on
page 29.