16
Setting Up the Kaleido-X (7RU) Multi-Viewer
Loading a Layout
2
3. Press ENTER again to obtain the room list from the Kaleido-X systems that are currently available on
the network.
The message
ROOM Select
followed by the name of the first room available appears on the LCD
display.
4. Press the
2
key (to move up in the list) or the
8
key (to move down the list) until the name of the room
you wish to access is displayed.
5. When the desired room name is visible, press ENTER, and then press ESC to exit the configuration
menu.
6. Press the LOGIN button.
The following message appears on the LCD display:
LOGIN Position
Admin
7. Press ENTER to log on to your system as “Admin”.
A message prompting you for a password appears on the LCD display.
8. Press ENTER again (by default, there is no password).
The message “Access granted” will appear on the LCD display if the login is successful. If a mouse is
connected to the RCP2, then you should be able to see and move the mouse pointer on the monitor
Press any of the LAYOUT PRESETS buttons to load a predefined layout on the monitor wall.
wall.
If your system was configured prior to shipment, then a layout will appear on all displays. Otherwise,
a gray screen will appear with the following message in the middle:
“No layout has been assigned to this room. Please load a layout.”
Loading a Layout
To load a layout on the monitor wall:
1. Connect a mouse to the RCP2.
Note:
By default, the two head (DVI/VGA) outputs from each of the Output A, B, C and D cards are
assigned to ROOM1, ROOM2, ROOM3 and ROOM4 respectively.
Note:
To access other layouts, press the LOAD button. To assign a layout to a preset button, press and
hold the button for more than six seconds while the desired layout is showing on the monitor wall.