Miranda Kaleido-X (4RU), Руководство пользователя, Страница: 303 / 388

293
This feature is particularly useful when mapping a large number of destinations
Note: If you make a mistake, click Clear mapping and then click Yes in the confirmation message that
appears to delete the table entries in the physical output column. This does not affect the Labels
column.
9. Click Import labels to import labels from a CSV (comma-delimited) file. A file browser appears,
allowing you to select a CSV file (such as might be exported from an Excel spreadsheet).
The file must be formatted as three columns with no header row. Column 1 should contain numbers
from 1 to N (the number of sources), column 2 should contain the source labels, and column 3 should
contain the destination labels. Columns are delimited by commas, without spaces.
Sample label file:
1,VTR 1,OUT 1
2,VTR 2,OUT 2
3,CAM 1,OUT 3
4,CAM 2,OUT 4
5,SAT 1,PGM
6,SAT 2,PVW
10. Select the Auto update labels check box to import labels directly from a router.
Note: Labels are imported at runtime (i.e. they only appear on the monitor wall, not in XEdit). This
feature applies only to certain router protocols:
– ETL Matrix
– HRS-1801
– NVision NV9000 Protocol
– Pro-Bel General Remote Control Protocol (SW-P-08)
– Thomson / Grass Valley GVG 7000 Native Protocol
– Utah Scientific RCP-3 Protocol
The list of supported protocols appears at the bottom of the Source mapping and Destination
mapping tabs.
11. As with destinations, the sources of the logical level must be associated with sources on the physical
router. Click the Source mapping tab. The table works in the same way as for outputs, except that the
number of rows is determined by the number of sources specified when the logical level was created.