Spirolab
Rev.1.8
Page 51 of 60
To make the connection, insert the
micro USB connector supplied with
the
spirolab
into the USB port on the
PC.
When you first connect, your PC,
depending on the operating system
version in use, will automatically
install the Microsoft certified driver.
For more support at this stage, refer
to the WinspiroPRO software
manual.
3.3
Printing data
Spirolab enables you to print both the last test performed and those stored in the archive.
To print the last test performed, retrieve
the test using the icon
for
spirometry or
for oximetry. When
you have viewed the test, press the icon
.
If in the service menu it was enabled the
direct USB printing, then on the screen
appears a banner which allows to choose
the type of printer to use:
thermal printer
USB direct connection printer
Choose one function in 5 seconds (when all the balls become orange); if no function is
selected, then after 5 seconds the thermal printed will start automatically.
If the direct USB printing is disabled, then touching the icon
will start automatically
the thermal printer.
To print a test carried out in the past and stored in the archive, perform a search as
described in section 2.7.1; once displayed, tap
.
Also in this case it will appear the banner to select the printing type: thermal printer or via
USB connection.
The system prints the information selected in the "Spirometry" - "Results" settings.
