MIOX RIO Zuni 1, Инструкция по установке, эксплуатации и обслуживанию

Страница: 20 / 46

MIOX RIO Zuni™ Operators Manual
P/N: 102-00094-I Page 20
NOTE: Oxidant tank level switches must be installed correctly for the
system to operate.
9) Hydrogen Venting
Install hydrogen venting in the oxidant tank. Hydrogen must be vented outdoors.
Follow the Hydrogen Vent Kit instructions in the Oxidant Tank Manual and MIOX
Hydrogen Safety White Paper.
10) Attached Power Cord
Attach power cord to IEC on the back panel of OSG. Connect to 220-240 VAC. For a
220-240 VAC connection, replace the supplied power cord with a 10A rated 220VAC
IEC Cable (220VAC cable not provided by MIOX).
11) Open Valves on OSG
Open the water and brine feed valves on the OSG.
12) Open Water Source Valve
Open the facility water source valve.
13) Brine Saturation
Wait 30 minutes to 1 hour to allow brine to fully saturate before turning system on.
14) Turn System On
Turn on the unit by switching the power switch on the back panel. The RIO Zuni will
enter into a priming cycle. RIO Zuni will automatically start producing oxidant after
the system has completed the priming cycle.
NOTE: Visually verify that water and brine are being delivered to the
plumbing I/O panel on the back of the OSG.
If water and/or brine are not visibly entering the OSG at the end of the priming
cycle, restart the priming cycle by turning the unit off, waiting 5 seconds, then
turning the unit on again. Wait for the priming cycle to end and then repeat this
process until both water and brine are successfully delivered to the plumbing I/O
panel. Refer to the troubleshooting guide located within this manual if system does
not start after priming cycle.