5
INSTALLATION
To successfully install the Captis device you must perform the following steps:
1.
Mount your Captis Power+ to a DIN rail
2.
Connect the Captis Power+ to DC power supply
3.
Terminate the sensor
4.
Test the sensor and test connectivity
Mount your Captis Power+
Your Captis Power+ must be mounted on DIN rail and ensure the fastening clip on the back of the
device is engaged.
When mounting your Captis Power+, ensure that there is enough length in the sensor cable to reach
without any undue stress.
Note: If the Captis Power+ is to be installed inside a metal cabinet, an external LTE antenna must
be used and routed to an open area where cell signal is less obstructed.
Содержание Captis Power+
Страница 1: ...1...