background image

25

24

IF THE UPS REQUIRES SERVICE

1. Use the Troubleshooting section to eliminate obvious causes.
2. Verify there are no tripped circuit breakers and that the batteries are good.

A tripped circuit breaker and defective batteries are the most common iss-
ues.

3. Call your dealer for assistance.  If you cannot reach your dealer, or if they

cannot resolve the issue call or fax the Technical Support department at the
following numbers; Voice phone (972) 446-7363, FAX line (972) 446-9011
or visit our Web site at www.minutemanups.com the "Discussion Board".
Before calling the Technical Support Department have the following infor-
mation available:
a)

Contact name and address.

b)

Where and when the unit was purchased.

c)

All of the model information about your unit.

d)

The serial number of your unit.

e)

Any information on the failure, including LEDs that may be illuminated
or error codes displayed.

f)

A description of the protected equipment including model numbers, if
possible.

g)

A technician will ask you for the above information and if possible,
help solve the issue over the phone.  In the event that the unit requires
factory service, the technician will issue you a Return Material Autho-
rization Number (RMA #).

h)

If the unit is under warranty, the repairs will be done at no charge.  If
the unit is not under warranty there will be a charge for the repair.

4. Pack the unit in its original packaging.  If the original packaging is no lon-

ger available, ask the Technical Support Technician about obtaining a new
set.  It is important to pack the unit properly in order to avoid damage in
transit.  Never use Styrofoam beads for a packing material.
a)

Include a letter with your name, address, day time phone number,
RMA number, a copy of your original sales receipt, and a brief desc-
ription of the problem.

5. Mark the RMA # on the outside of all packages.  The factory cannot accept

any package without the RMA # marked on the outside.

6. Return the unit by insured, prepaid carrier to:

Para Systems Inc.
MINUTEMAN UPS

1809 W. Frankford Road, Suite 150

Carrollton, TX 75007

ATTN: RMA # _______

Chapter 7: Obtaining Service

Chapter 8:  Specifications

Default: 208VAC, User selectable: 220/230/240VAC

Protection

Waveform Type

Over-Current, and Short-Circuit Protected

True Sine Wave

Frequency

50/60Hz, +/-0.1Hz

Nominal Voltage

Maximum Power Capacity

0 ms

>90% (Full Load)

Resettable Circuit Breaker

40  to 70 Hz, autosensing

0 - 300VAC

180 - 280VAC

208VAC: 204 - 212VAC

Transfer Time

Efficiency (On-Line Mode)

Input Protection

Frequency Limits

Voltage Range

Acceptable Input voltage

Model Number

SYSTEM SPECIFICATIONS

Voltage Range

Topology

Double Conversion On-Line, True Sine Wave

OUTPUT ON-LINE OPERATION

INPUT

Number of Phase

Single (1

 

2W +G)

Nominal Voltage

208VAC

Low Voltage Transfer Point

156/180V resets to Utility Power at 166/190V or higher

High Voltage Transfer Point

280V resets to Utility Power at 270V or lower

Voltage Regulation

N/-2%

Frequency Range

50/60Hz, +/-0.1Hz (unless synchronized to utility)

OUTPUT BATTERY OPERATION

Voltage Regulation

N/-2% (until Low Battery Warning)

Voltage T.H.D.

<2% (Linear Load)

+/-5% @ 100% Load change in 30 ms

Dynamic Response

Slew Rate

<1Hz / second

Overload Capacity

>106% - <110% for 10-minutes
>111% - <125% for 5-minutes
>126% - <150% for 30-seconds

156 - 280VAC

Power Factor Correction

>99% at Full Load

Crest Factor

3 : 1

5000VA
4500W

6000VA
5400W

ED10000RT-CU

8000VA
7200W

10000VA
9000W

ED8000RT-CU

ED6000RT-CU

ED5000RT-CU

2.7 : 1

NOTE:

  Specifications are subject to change without notice.

Содержание 90001214

















Отзывы: