Minster IOI, Руководство по обслуживанию

Страница: 18 / 92

rocking motion that could occur from their
use. Such rocking motion may induce
accelerated bearing wear. To suppress
excessive vibration from the operation of
your OBS stationary (not inclinable) press,
only resilient laminated fabric or rubber
pads are recommended for use, such as
Fabreeka
®
or Unisorb
®
type brands. See
WARNING posted on inclinable Minster
OBI presses and as also found within the
“Minster Power Press Safety Manual No.
805” in section entitled “Signs of Safety.”
FRONT PANEL AND
LUBE LINE INSTALLATION
The press front panel was removed, and lube lines
relocated, to prevent damage during shipment. The
lube lines may be installed in their proper location and
the front cover may be reinstalled following the direc-
tions below.
1. Relocate the lube lines. The lines must be relocat-
ed from their shipping position within the press
crown cavity, and reinstalled on the front of the
press as shown in Figure 3C. Use line clips and
hardware provided.
2. Reinstall the front cover. Position the cover on the
front of the press and secure with four (4) .375” - 16
x .750” long Hex. Head Cap Screws and flat washers.
DRIVE V-BELT INSTALLATION
The drive v-belts transmit energy from the main drive
motor to the press flywheel. Install the drive v-belts fol-
lowing procedure outlined below.
WARNING
DISCONNECT POWER TO THE PRESS, LOCK THE
DISCONNECT SWITCH IN THE OFF POSITION, AND
ATTACH WARNING TAG TO PREVENT ACCIDEN-
TAL STARTING OF THE MAIN DRIVE MOTOR
WHILE INSTALLING, ADJUSTING, OR INSPECTING
THE DRIVE BELT.
1. Using a large machinists square, check alignment
of the motor sheave with the flywheel. If motor
sheave and flywheel do not align, loosen the motor
mounting bolts and shift the motor until both sets of
grooves are aligned accurately; otherwise, belts will
not track straight and will wear out rapidly. Misalign-
ment of the sheaves will also cause needless belt
groove wear and motor bearing damage. After
sheaves are correctly aligned, tighten the motor
mounting bolts fully.
2. Using the adjusting screw nuts, lower the main drive
motor toward the flywheel until v-belts can be
slipped over motor sheave and flywheel without
strain. (See Figure 4C.)
WARNING
DO NOT FORCE THE V-BELTS OVER THE SHEAVE
GROOVES.
C - 5
Install Lube
Lines Here
(Under Clamps)
Figure 3C. Lube line installation.
Figure 4C. Installing v-belts.
!
Adjusting
Screw Nuts
V-Belt
!