Extra Bike Cradle 3
– instructions manual
<Applicable Tube Diameter: 38 – 45mm>
40mm = for BikeTower / BikePit upper pillar
45mm = for BikeTower / BikePit lower pillar, P-500 / 600 / 700 pillar
1
Open the Clamp Band and
wind around the pillar (see
Fig. B).
Align all 3 holes on the arms
after closing.
In case of installing on
43mm or narrower diameter
pillar such as the upper
pillar of BikeTower or
BikePit, add the Plastic Shim
under the Clamp Band.
The shim is not necessary
when installing on the fatter
45mm diameter pillar.
Make sure the single side
arm sits between the double
rails on the shim.
!
BikeTower
lower pillar
(45mm
diameter)
BikeTower upper pillar
(40mm diameter)
Install Shim
3
Put the Pivot-Pin through all 3 holes
from the bottom side, and screw the
Pivot-Pin Fixing Bolt with a washer
into the Pivot-Pin (see Fig. D).
!
If you try to install the Pivot Pin
from the bottom, you won't be
able to tighten the bolt correctly.
Follow the instructions precisely.
!
Do not tighten the bolt firmly
yet at this moment.
Left side Arm (foreside)
Right side Arm
(backside)
Cradle Cap
Hook
Base Plate
Clamp Band
Plastic Shim
(use on 43mm or smaller
diameter)
Metal Collar
(Left side only)
Pivot-Pin
Pivot-Pin Fixing Bolt
Hook Fixing Bolt
Left Arm Angle Fixing Bolt
Right Arm Angle Fixing Bolt
Arm Connecting
Bolt
Clamp Tightening
Bolt
How To Install the Cradle
1
2
First, disassemble the
Clamp Band and open it so
the pillar can be installed.
Then remove the Clamp
Tightening Bolt, then the
Pivot-Pin Fixing Bolt using
an M5 hex wrench.
(see Fig. A)
2
(Cradle is not shown here for describing about the clamp band)
Required Tool:
1 x 5mm Hex Wrench
(Fig. C)
(Fig. A)
(Fig. B)
(Fig. D)
4 944924 422172
4 944924 422172
CRADELE 3
(ver.1.1 2014/8)
!
We suggest wrapping
the hook with bar tape to
minimize discoloring of
lighter colored frames.
!
