miniDSP Ltd, Hong Kong /
/ Features and specifications subject to change without prior notice
13
3
O
FF
-
THE
-
SHELF ACCESSORIES AND CONNECTION
3.1
VOL-FP
VOL-FP is a small board intended for mounting on the front panel of an enclosure. It contains a rotary encoder,
infrared receiver, and status LEDs. It provides volume control, preset selection, and digital input selection
(applies when used together with DIGI-FP or DA-FP).
After mounting in the enclosure, connect the supplied 5-pin cable between the VOL-FP board and the
miniSHARC board as shown in the photograph below. Note carefully the orientation of the connectors as shown
in the photograph.
3.1.1
Operation of VOL-FP
To change the volume
Rotate the control knob clockwise to increase the volume, and counter-clockwise to decrease it.
If the computer is connected and the plugin is in online mode, the Master Volume display in the
plugin updates accordingly. (This is not necessary for normal operation, but can help with
troubleshooting if needed.)
To change the selected source
Briefly press the control button. The
Digital Source
LED blinks quickly. Rotate the control knob
until the desired source LED is blinking. Press the control knob again, and the selected LED will
remain steady. The preset LED will now blink.
To change the selected preset
After changing source selection, rotate the control knob until the desired preset LED is blinking.
Press the control knob again, and the selected LED will remain steady.
