miniDSP Ltd, Hong Kong /
/ Features and specifications subject to change without prior notice
26
4.10
O
UTPUT MODE SELECTION
The output mode is shown at the bottom of each channel when the plugin is in online mode. The screenshot on
the previous page shows the factory default setting, with all channels in Line Out mode. To change the mode,
click on the button. Odd-numbered channels can be selected between Line Out, BTL or PBTL:
Even-numbered channels can be selected between Line Out or BTL:
Note that output mode is independent of the selected preset configuration.
Because PBTL mode applies to a pair of channels, the corresponding even-numbered channel is greyed out on
the Output and Mixer tabs when PBTL mode is selected:
Turn off the power to the Harmony DSP 8x12 after changing output mode, and then re-apply
power. You can do this by taking the Remote trigger input low and then high again, or by
removing power entirely and then re-applying it. Be sure to follow the instructions provided by
the plugin when changing modes.
