Mini Clubman 2019, Руководство пользователя

Страница: 158 / 324

Resetting the system
Via the Central Information Display (CID):
1. "My MINI"
2. "Vehicle status"
3. "Tire Pressure Monitor"
4. Start the engine but do not drive off.
5. Reset the tire inflation pressure using
"Perform reset".
6. Drive away.
The wheels are displayed in gray and the
following is displayed "Resetting Tire
Pressure Monitor…".
After driving faster than 19 mph/30 km/h
for a short period, the set tire inflation pres-
sures are accepted as reference values. The
resetting process is completed automati-
cally while driving.
After successful completion of the reset, the
tires appear in green on the Control Display
and "Tire Pressure Monitor active. See label
for recommended pressures." is displayed.
You may interrupt this trip at any time.
When you continue the reset resumes auto-
matically.
Messages
General information
A low tire inflation pressure may cause the
DSC Dynamic Stability Control to be
switched on.
Safety information
WARNING
A damaged regular tire with low or miss-
ing tire inflation pressure impacts han-
dling, such as steering and braking re-
sponse. Run-flat tires can maintain limited
stability. There is a risk of an accident. Do
not continue driving if the vehicle is
equipped with normal tires. Follow the in-
formation on run-flat tires and continued
driving with these tires.
If a tire inflation pressure check is
required
Message
A symbol with a Check Control message ap-
pears on the Control Display.
Symbol Possible cause
The system has detected a
wheel change, but no reset was
done.
No reset was performed for the
system. The system issues a
warning based on the tire infla-
tion pressures stored during the
last reset.
Inflation was not carried out ac-
cording to specifications.
The tire inflation pressure has
fallen below the level of the last
reset.
Measure
1. Check the tire pressure and correct as
needed.
2. Reset the system.
If the tire inflation pressure is too low
Message
A yellow warning light is illuminated
in the instrument cluster.
In addition, a symbol with a Check Control
message appears on the Control Display.
Seite 158
CONTROLS Safety
158
Online Edition for Part no. 01402723718 - VI/18