SC-600RF
Wireless CamCatch
Opera on Manual
2.Battery Install
1) Releave the Batt. Compartment cover on the back and put into the Batt.
pack. (please notice the side of the )
+/-
3.Battery Charge
1) Use the attached power adaptor to charge/power the unit.
( Dont use any other power supply or source from any computer)
4.Charge Indication
1)The red LED goes on under charging while off completing the charge
，
5.Low Power Alert
1) A low-Batt. icon will keep flash on the main screen
，
1.Name and Parts
6.Antenna Installation
1) Screw on the antenna according to the number indication
Screw on the Labeled 1 Ant. into the Socket 1
Screw on the Labeled 2 Ant. into the Socket 2
Screw on the Labeled 3 Ant. into the Socket 3
7.Power Switch
1) Push and hold the power button for 3 seconds to open/close the power.
Once power on the unit will start to scan automatically.
Note: Be sure installing all antennas before power on
8.Frequency Scan
1) The picture will be shown on the monitor for a certain dwell time
which
＇
ve been setup with in previous, once any signal been detetected
pull up or down the setup key to hold the frequency, otherwise will
continue to browse in next.
1.Set-up Key
2.Low Band Antenna Mount
(900 MHz ~ 2324 MHz)
3.High Band Antenna Mount
(2325 MHz ~ 3000MHz / 5000 MHz ~ 6000MHz)
4.
20MHz~6GHz Antenna Mount
5.Power Button
6.AV Input Output Port
/
7.Charge LED
8.Power Input
9.LCD Setup Screen
10.LCD
11.Battery Tray
Video Monitor
