Minelab Manticore, Инструкция по эксплуатации

Страница: 69 / 78

CONTENTS
69
Errors
In the event of an Error, try the recommended actions
listed� If they do not resolve the Error, or for Errors that
are not listed here, please contact a Minelab Authorised
Service Centre�
CRITICALLY LOW BATTERY ERROR
Critically Low
Battery
Shutting Down...
The Criticality Low Battery
Error message�
The detector will shut‑down
automatically 5 seconds
after reporting this Error�
To resolve the Error, try the following:
1. Recharge the battery or connect a USB power bank�
2. Check that you are charging from a USB charging
source with a 2 A @ 5 V charging capacity�
3. If charging from a lower‑powered USB port (such as
a laptop port), the detector may be discharging the
battery at a faster rate than it is charging� This prevents
the charge indicator from appearing — try charging with
the detector switched Off�
4. Avoid using a USB extension cable when charging�
COIL DISCONNECTED ERROR
Coil
Disconnected
Shutting Down...
The Coil Disconnected Error
message�
The detector will shut‑down
automatically 5 seconds
after reporting this Error�
To resolve the Error, try the following:
1. Check that the Coil Connector is connected properly at
the back of the Control Pod�
2. Check the Coil Cable and Coil for visible signs of damage�
3. Try another Coil, if you have one available�
4. Contact a Minelab Authorised Service Centre�
SOFTWARE UPDATE FAILED ERROR
A Software Update Failed Error can occur when a critical
part of the software update fails preventing the detector
from functioning� This is recoverable by the user, and can
occur when the software update is interrupted, for example
if the magnetic USB cable is disconnected during the
update�
To resolve the Error, try the following:
1. Try updating the detector software again�
2. Ensure the magnetic USB cable remains securely
connected while the update is in progress, until the
Minelab Update Utility (MUU) reports that the update
has been successfully completed�