Minelab EQUINOX 700, Инструкция по эксплуатации, Страница: 18 / 61

* EQUINOX 900 only
18
CONTENTS
Sensitivity
The EQUINOX Series detectors are highly
sensitive and have adjustable Sensitivity� Setting
the correct Sensitivity level for individual
detecting conditions will maximise detection depth�
Always choose the highest stable Sensitivity setting to get
the best performance from your detector�
The Sensitivity Indicator on the LCD shows the approximate
Sensitivity level in increments of 5�
Sensitivity ranges from 1 to 25 for the EQUINOX 700, and
1 to 28 for the EQUINOX 900�
Level 1–5 Level 6–10 Level 11–15 Level
16–20
Level
21–25
Level
26–28*
ADJUST THE SENSITIVITY LEVEL
Before reducing the Sensitivity, always try to
resolve noise by first performing:
ƒ
Noise Cancel (page 25) , followed by
ƒ
Ground Balance (page 26)
The Sensitivity Level is shown on the Target ID Display
while it is being adjusted, and will disappear after 3
seconds of inactivity�
1. Holding the coil stationary, use the Plus button to
increase the Sensitivity level until false signals begin to
occur�
The Plus button
2. Reduce the Sensitivity level by pressing the Minus
button, just enough that the false signals disappear�
The Minus button
3. Sweep the coil over a clear patch of ground, and
decrease the Sensitivity Level further if there is still
some ground noise�