MP 26/10
Installation and Calibration Manual
Minebea Intec
EN-15
3.5.4.
Load and Store Setup and Configuration
Load Data to / from MP26 Device
The current data available on the device can be
loaded on to the pc software tool. To do this, go
to Device
Load data
ok. The loaded data can
be modified and saved back to the device using
by going to Device
save data to device
ok.
After pressing
OK
, the data will be loaded/
saved from/to the device.
Archive Data in the PC
The data set available can be stored as a project.bct in any of the preferred locations on the
PC. Similarly, the saved project.bct can be reloaded to the tool for further usage. Thus, all the
configuration details can be stored on the PC.
New:
For creating a new project.
Open:
For opening a currently saved project.
Save:
For saving the current parameters and configurations to
the project under modification.
Save as:
For saving the current project in the desired location.
