Minebea Intec Maxxis 5 Phase PR 5900/81, Руководство по эксплуатации

Страница: 55 / 94

7 Operation and visualization of the scales
7.1 General information
The visualized data and the possible/necessary operation depend on the current process.
7.2 Visualization
7.2.1 General
How the phases are displayed will depend on the batching mode you choose. The
batching modes are described in the PR 8400 P (Release 2.00) instruction
manual. The following rules apply:
- The key stops all active phases of the weighing points conigured on the
device.
- In a menu such as the coniguration or weighing point overview, you can use arrow
keys to navigate, a key to select the item you have marked and a key to exit the menu
item.
- Soft keys are shown only if the function related to these is permitted.
- If a phase has a status that requires intervention by an operator, the status of the
phase lashes gray on the overview page. In the weighing point view, the status is
also indicated by a colored marking on the irst line (red = Hold or Alarm; Yellow =
Material low warning).
- If intervention by an operator is required on another weighing point (e.g. WP
‑
B), but
WP
‑
A is currently being displayed, the status of the phase switches to WP
‑
A between
the current status and the notiication [Alarm WP
‑
B].
7.2.2 Bar graph and tolerance ield
In the case of both automatic and manual batching, a bar graph appears over the weight
display, which is always scaled to the set point for the current material.
The tolerance ield is labeled and is always the same width irrespective of the absolute
value. The set point is marked using 2 triangles and is always (even if the tolerance is not
symmetrical) in the middle of the ield.
As soon as the tolerance ield is reached, the color changes from orange to green. If the
ield is exceeded, the bar graph becomes red.
If both tolerance values are set to 0, then no tolerance ield is displayed and the bar graph
changes from green to red when the set point is exceeded.
7 Operation and visualization of the scales Phase PR 5900/81
Minebea Intec EN-53