Minebea Intec CSD-918 Series, Руководство по эксплуатации

Страница: 91 / 240

10.3.3 Tables of external control output data function
The functions which can be set to the external control output are as follows;
Items Contents
[OFF] No setting
[STABLE] The signal is output during stable.
[ZERO BAND] The (Empty) signal is output in zero band.
[FULL] The signal is output in full.
[FULL FLOW] The signal is output in executing the full low.
[MEDIUM FLOW] The signal is output in executing the middle low.
[DRIBBLE FLOW] The signal is output in executing the ine low.
[OVER] The signal is output in weighing value being over.
[OK] The signal is output when the weight value is OK.
[UNDER] The signal is output when the weight value is under set point.
[MIXING] The signal is output in executing the MIXING.
[DISCHARGE (GATE
OPEN)]
The signal is output in executing the discharge.
[BATCH FINISH] The signal is output in inishing the batching.
[DISCHARGE FINISH] The signal is output in the inish of discharge.
[MIXING FINISH] The signal is output in the inish of mix.
[NOZZLE DOWN (IN-
SERT)]
The signal is output when the nozzle is down.
[DURING MEASURE-
MENT]
The signal is output in the weighing.
[WEIGHING SEQ. ERROR] The signal is output when the sequence error is caused.
[ERROR]
The signal is output when the error is occurred.
Refer to Chapter 19.2.1 , 19.2.2 , 19.2.3 und 19.3 .
[CAP. EXCEEDED ERROR] The signal is output when the OL condition is satisied.
[DURING TARE]
The signal is output when the tare weight cancellation is exe-
cuted.
[CENTER OF ZERO] The signal is output in the condition of the center zero.
[GROSS DISPLAY] The signal is output when the display is the gross value.
[NET DISPLAY] The signal is output when the display is the net value.
[DURING HOLD] The signal is output during the holding operation is made.
[SERVO ERROR] The signal is output when the error is occurred. The targeted
errors are [SV.ERR EMG], [SV.ERR ALM].
10.3.4 Function of External control output logic
Output logic of I/O output from 1 to 11 is selectable from [NEG.][ (negative logic)] or
[POS.] (positive logic).
10 I/O setting (I/O) Weight Controller CSD-918
Minebea Intec EN-89