Minebea Intec CSD-918 Series, Руководство по эксплуатации

Страница: 46 / 240

Note:
Error display of Zero calibration
[TE-L]: Blinks for about 2 second when load cell output voltage is lower than
-2.5 mV/V (Refer to Chapter 19.2 ).
[TE-H]: Blinks for about 2 second when load cell output voltage is higher than
2.5 mV/V (Refer to Chapter 19.2 ).
6.3.7 SPAN calibration (SPAN ADJUSTMENT)
The input at SPAN is registered.
There are two methods for SPAN calibration.
- Calibration method with weight
- Calibration method by numeric input of load cell output voltage
6.3.7.1 Calibration method with weight
SPAN calibration is proceeded with the weight put on the weighing section.
When there is the same mass of weight as the weighing capacity, please input the
same amount as the max. load (Max).
If there is not the same calibration weight as the max. load, please input the amount
of weight to be used for calibration.
Tap [NO] to interrupt the calibration, and tap [BACK] or [TOP] to proceed.
Note:
Please use the calibration weight for the SPAN calibration to be used for the amount of
2/3 or more of the max. load (Max) to reduce the calibration error.
6.3.7.2 Calibration method by numeric input of load cell output voltage
This is the method of SPAN registration by inputting the diference subtracted from the
output voltage at span of load cell to the output voltage at zero point.
Please input the arbitrary amount in the range from [0.000 01 mV/V] to [3.100 00 mV/V].
1. Select [SPAN ADJUSTMENT] on weighing calibration screen 1/2.
2. Please input the value of the weight applied on the weighing section actually.
3. Check that the inputted content on the input conirmation display section with ten
keys is relected.
4. Tap [OK].
The message of [Has ZERO calibration completed? Execute SPAN calibration?] is
appeared.
5. Tap [YES].
If the display has returned to load calibration screen 1/2 after blinking the
[SPAN], the SPAN registration is inished.
The [SPAN] display blinks in the load display section.
1. Tap [SPAN POINT mV/V] at the calibration screen 1/2.
Weight Controller CSD-918 6 Calibration
EN-44 Minebea Intec