Minebea Intec CSD-918 Series, Руководство по эксплуатации

Страница: 226 / 240

Note:
-
The error command is not returned if the address and completion code (terminator)
cannot be detected.
- Dealing with this on the host side if the communication error command is returned
from the device.
- Values are entered from the right.
- Set the number of characters for command setting section to 15 characters during
reading/writing [BRAND]
- Sending error condition is as follows:
- There is a disagreement in scale interval.
- Characters other than numerical values are input for the set value.
- Characters other than [+] or [–] are set under sign.
20.4.1.12 Read command list
Item
name
Command name Command No. Return command setting value
BRAND CODE 70 01 0 to 99
NAME 70 02 Katakana, alphanumerical values (15 characters)
BRAND Hopper No. 70 03 0 to 99
FINAL 70 04 0 to 999 999
FREE FALL 70 05 -99 999 to 999 999
PRELIMINARY1 70 06 0 to 999 999
PRELIMINARY2 70 07 0 to 999 999
OVER 70 08 0 to 999 999
UNDER 70 09 0 to 999 999
ZERO BAND 70 10 0 to 999 999
FULL 70 11 0 to 999 999
A. F.F. COMPENSATION 70 12 -0 to 999 999, 0: A. F. F. COMPENSATION OFF
SUPPLEMENTARY FLOW
TIME
70 13 0.00 s to 99.99 s (Unit: 0.01 s)
JUDGE. AFTER S-FLOW
WAIT
70 14 0.00 s to 99.99 s (Unit: 0.01 s)
BRAND ACCUM. VALUE (8
digits)
70 15 -99 999 999 to 99 999 999
BRAND ACCUM. COUNT 70 16 0 to 999 999
PRESET TARE 70 17 0 to 999 999
BRAND
setting
INITIAL FULL FLOW 70 18 0 to 999 999
Weight Controller CSD-918 20 Appendix
EN-224 Minebea Intec