Mine Site Technologies NS50, Руководство пользователя, Страница: 98 / 126

# Power over Ethernet
# ===================
#
switch.poe.enabled = 1
The parameters shown in the example device configuration file are described in the following table.
Settings Description Parameter Section
Each device should have a unique
name identifier. Network switch name. system.hostname System
It is recommended the location name
is relevant to the physical location of
the device. Location name of the
network switch. system.location System
Every WAC will be assigned a unique
IP address. IP address of the WAC
in the network switch. network.addr Network
It is recommended WACs in proximity
of each other have assigned channels Wi-Fi channel that the
WAC will operate on. wireless.radio.channel Wireless Radio
Configuration
1, 6 and 11. This minimises signal
overlap and interference.
0 = Disabled 1 = Enabled Enabling PoE supply on
the network switch. switch.poe.enabled Power over
Ethernet
Note: This setting is not
applicable to WAPs and will be
ignored when the file is applied
to a WAP.
To edit a device configuration file:
1. Open a text file editor on your PC.
2. Locate and open the device configuration file ap_MACaddress_settings.conf. This is usually stored
in the file directory folder of the TFTP server.
3. Edit the parameters as required.
4. In the directory folder of the TFTP server, save the file using the naming
ap_MACaddress_settings.conf, where MACaddress is the MAC address of the WAC card to
configure.
6.6 Applying Configuration Files
To apply configuration files to a network switch:
1. Connect a PC to the network or network switch. Refer to Connecting a PC to an ImPact Network
Device on page 115 for more information.
2. Check the TFTP server is connected and running on the same network as the network device. If the
TFTP server is being run on the PC, open the TFTP server application.
3. Open a Telnet software utility on your computer. For a PC with Windows OS, open the command
prompt.
4. Type Telnet xxx.xxx.xxx.xxx (where xxx.xxx.xxx.xxx is the IP address of the WAC card in the ImPact
network device to be updated). The login screen will be displayed.
Revision A 98 NS50 User Manual
Centralised Configuration Management