Mine Site Technologies NS50, Руководство пользователя, Страница: 89 / 126

Note: The same site configuration file can be used to configure network switch units and WAPs
in a network. When the site configuration file is applied to WAPs, all switch port settings are ignored
by the WAP.
6.3 Editing Site Configuration Files
The site configuration file can be opened on a PC and edited using a text editor. Parameters are changed
by modifying the text and saving the file. A description of the editable parameters are covered in the
following sections.
To edit a site configuration file:
1. Open a text file editor on your PC.
2. Locate and open the site configuration file ap_site_settings.conf. This is usually stored in the file
directory folder of the TFTP server.
3. Edit the parameters as required.
4. Save the site configuration file in the directory folder of the TFTP server.
6.3.1 Network
The network section of the configuration file defines common LAN settings to all devices on a network
as shown below.
# Mine Site Technologies Wireless Network Switch / Wireless Access Point Site
Config File
# Network
# =======
network.netmask=255.255.255.0
network.gateway=10.11.12.1
network.dns.primary=10.11.12.1
network.dns.secondary=
network.local_domain_name='minesite.com.au'
A description of the network parameters are listed in the following table.
Description Text field
The subnet mask for the network. network.netmask
The IP address of the default gateway. network.gateway
The DNS server to be used when looking up host names. network.dns.primary
The backup DNS server to be used when looking up host
names. network.dns.secondary
The domain name of the local network. network.local_domain_name
NS50 User Manual 89 Revision A
Centralised Configuration Management