Mindray DP-50 Exp Vet, Руководство оператора

Страница: 43 / 343

System Preparation 3-1
3
System Preparation
3.1 Moving / Positioning the System
Please read and understand the safety precautions before placing the system to ensure
safety for both operator and devices.
1. Switch off the power, and pull out the plug.
2. Disconnect the system from all peripherals.
3. Place the system in a desired location by holding the handle.
4. Leave at least 20cm at the back and both sides of the system.
CAUTION:
Maintain enough space around the back and both sides of
the system for plugging/ unplugging the power cord freely,
as well as avoiding system failure resulted due to
increased system operating temperature.
3.2 Power Supply
This system can work normally only when it is connected to the external power supply or the
battery capacity is sufficient.
3.2.1 Connecting External Power Supply
A three-wire power cord is used to connect the system with the external power supply.
The external power supply system must meet the following requirements:
Voltage: 100-240V
～
Frequency: 50/60Hz
Input current: 1.5- 0.8 A
3.2.2 Powered by Battery
When connected to the external power supply, the system is powered by the external power.
The lithium ion battery inside it is in charging status. When disconnected from the external
power supply, the system is powered by the lithium ion batteries.
Refer to
“
13 Battery
”
for the detailed operations and precautions.