Operation
Startup
Note
: Before applying power, verify that no conductive material is present on the printed
circuit board.
To start the drive:
Turn the speed adjust potentiometer full counterclockwise (CCW). If the drive is follow-
ing a voltage signal, set the voltage signal to 0 VDC.
Apply AC line voltage.
Slowly advance the speed adjust potentiometer clockwise (CW). If the drive is following
a voltage signal, slowly increase the voltage signal. The motor slowly accelerates as
the potentiometer is turned CW, or the voltage signal is increased. Continue until the
desired speed is reached.
Remove AC line voltage from the drive to coast the motor to a stop.
If the motor or drive does not perform as described, disconnect the AC line voltage immedi-
ately. Refer to the
Troubleshooting
section for further assistance.
Line starting and line stopping
Line starting and line stopping (applying and removing AC line voltage) is recommended
for infrequent starting and stopping of a drive only. When AC line voltage is applied to the
drive, the motor accelerates to the speed set by the speed adjust potentiometer. When AC
line voltage is removed, the motor coasts to a stop.
1.
2.
3.
4.
Содержание XP-AC Series
Страница 30: ...24 NOTES...