MIMAKI tx300p, Руководство по эксплуатации, Страница: 45 / 130

2-15
2
2
2
5
6
Chapter 2 Basic Operation
Setting of the manual media width
setting
When [
MEDIA DETECT
] of the machine setup is
“MANUAL” ( P.3-15 ), set the media width in the
following method.
1
Display the “MEDIA DETECT” screen.
2
Select the print area setting method.
• When setting the print area, use either "Manual"
to set the right and left edge of the media using
the jog key, or “Media width input mode” to set the
right edge of the media after inputting media
width.
• When “Manual” is selected, proceed to Step 3.
And when “Media width entering mode” is
selected, proceed to below.
(1) Press [

][

], and enter the media width.
(2) Press the [ENTER] key, and perform after
step3.
3
Press to set a light point of the
LED pointer to the right edge position of
the media.
• Press [

][

] to move the carriage, and align the
built-in LED pointer with the right edge of the
media.
4
Press the key.
• Next, the screen to enter the left edge position of
the media is displayed.
When “Media width entering mode” is selected on
step 2, this setting is end without display this
screen.
5
Press to set a light point of the
LED pointer to the left edge position of the
media.
• In the same manner as in step 3, align the light of
the LED pointer to the left edge of the media.
6
Press the key.
Entering media thickness
If the thickness input setting in [MEDIA DETECT] in
machine setup is turned “ON”
( P.3-15), set the
media thickness as follows:
1
Display the screen for entering the media
thickness.
2
Press to enter media thickness.
3
Press the key.
40
° /
50
°
MEDIA DETECT
PRINT AREA [WIDTH] MANUAL
40
° /
50
°
RIGHT EDGE POSITION
• If you do not perform over printing, be careful not
to set the position beyond the media range, as it
may cause printing or outside the media.
40 ° / 50 °
LEFT EDGE POSITION
40
° /
50
°
INPUT MEDIA THICKNESS
THICKNESS 0.1mm