MIMAKI Tx300P-1800B, Руководство по эксплуатации, Страница: 85 / 144

3-25
1
2
3
4
5
6
Chapter 3 Confirming Machine Information
Printing Check Flow
Nozzle check is conducted according to the following flow at the start of printing.
Printing Operations at “Nozzle Missing” Judgment and Error Occurrence

When judged to be “Nozzle Missing”

Printing is stopped.

When error occurs during nozzle check

Printing is stopped and “Printing Check” is automatically
turned OFF. After recovering from the error, set “Printing
Check” once again.
• Turn the “Printing Check” setting ON to be enabled.
• Only perform RETRY COUNT and Printing Check settings when the settings are enabled.
1
nozzle check

Judgment
2
3
Recovery operation

nozzle check

Judgment
4
Retry

Judgment
Printing Check

Judgment
Detects missing nozzles.
If more missing nozzles than “Judgement
Condition” are detected after the nozzle check,
cleaning is performed and nozzle check is
conducted again.
5
Nozzle Missing judgment If more missing nozzles than A are eventually
detected, continued printing will be deemed
impossible and printing will stop.
If more missing nozzles than “Judgement
Condition” are detected after the recovery
operation, the recovery operation is conducted
again.
Nozzle recovery is automatically conducted
following nozzle check and recovery operation.
• Turn the “Printing Check” setting ON to be enabled.