MIMAKI TextileJet Tx2-1600 Series, Руководство по эксплуатации

Страница: 124 / 154

- 4.10 -
Periodical cleaning of the wiper
Cleaning the wiper
The wipers are provided for cleaning the heads. As the device is used to plot images, the wipers
gradually become stained with ink and dust. Clean stained wipers.
The wiper is separately available from your local distributor or our office.
Notes on handling the wipers
• Avoid contacting the rubber portion of the new wiper. Contacting it will result in
clogged nozzl
• Clean the two wipers at a time.
•
The front side of each wiper is made of felt, and the rear side is made of rubber.
Do not rub the felt side with a swab. Instead, press the swab against the felt side
surface to remove dirt. Rubbing the felt side surface will make it fluffy and result
in clogged nozzle. Wipe ink off the rubber side surface with a swab.
•
When executing this function, the carriage will come out of the capping station. If
the carriage is left in the aforementioned state for an extended period of time, the
nozzles can be clogged. Once the replacement of the wiper and the cleaning of
the caps have been completed, immediately push the [ENTER] key to allow the
carriage to return to the capping station.
STEP
1. Move the carriage.
Execute the station maintenance [CARRIAGEout]. (Refer to
step 1 to 7 on page 4.8)
2. Open the maintenance cover.
3. Clean up the wiper as described below.
4. Execute steps 8 to 9 of the station mainte-
nance [CARRIAGEout] on page 4.9.
Felt surface
Capping station side
Rubber surface
Do not rub the
felt surmace
Rubber surface