MIMAKI ML Tiger-1800B MKII, Руководство по эксплуатации

Страница: 43 / 174

Chapter 4 Installation
4-3
1
2
2
4
5
6
Installation Requirement
Place the machine on a stable horizontal surface that has sufficient strength to support its weight and absorb vibration
during operation.
Use the light source (natural or artificial, or both) at the installation location to ensure a minimum illuminance of 300 [lux]
for the operator's normal workstation location and control panel location.
Environmental condition
This machine is designed to be used indoors under the following conditions.
• Installation: Up to 2000 [m] (above the sea level)
• Accuracy guarantee temperature: +20 to +25 [°C]; It is guaranteed that the unit functions properly at the specified tem-
perature. But, even small changes will affect printing.
• Allowable temperature: +15 to +30 [°C]
• Storage temperature: +5 to +35 [°C] is the proper temperatures.
• Relative humidity: Within the range of 35% to 65% (no condensation), normal operation is guaranteed.
• Electromagnetic field: Do not expose this unit, especially the cabinet, to a magnetic field that may interfere with opera-
tion.
• Mimaki assumes no responsibility for any illegal operation of this unit or operation that does not match the specification
specified when using this unit under conditions other than the above.
Means for removing vibration
By properly maintaining and lubricating moving parts, special vibrations will not occur in this machine. Therefore, when
vibration abnormality occurs, it is necessary to accurately check whether there are malfunction or abnormal wear of
movable parts.
Loading, Placement, Installation procedure
When arranging and installing this machine, specific work (such as lowering the removed parts and placement work etc)
can be done by the customer. As for other work (assembly of the machine and connection to the power supply), as
stipulated in the contract already, only the workers of Mimaki have authority to execute.
The operation is shown below.
• Place this machine in a place that was correctly treated by the purchaser in advance and place the floor
sufficiently to support the weight of the machine.
Procedure Loading, placement, installation procedure
S Mode Key Description Feature Reference
1 Remove the protective material from this machine.
2
Considering the size of this machine, confirm that the
installation location is clean and there are no
obstacles.
3
If the installation location does not meet the
requirements of the previous step, clean it to suit the
location of the machine.
4
Lift each module of the machine and place it on the
floor in a predetermined place.
5
Make sure that the projector and all its components
are level at zero level.
6 Connect various modules of this machine.
7
Connect the electrical system and the hydraulic
system.
4-7
8
Remove the packing (polyethylene, adhesive tape,
etc.) if it remains.
End of procedure
• The machine is equipped with a motor that is filled with oil and the whole is being lubricated.
• Since this machine is delivered in a packed state, it is not necessary to clean it before the first startup.