MIMAKI ML Tiger-1800B MKII, Руководство по эксплуатации

Страница: 127 / 174

Chapter 7 Operation, Adjustment, and Maintenance
7-7
7
2
3
4
5
6
Replacing Squeegee Blade
The squeegee blade is a rubber device used to remove washing water from the belt.
Because the squeegee blade is made of rubber, it will not be possible to properly clean the work due to the influence of
wear, depending on the type of treatment after a certain period of time.
To replace, follow the procedure below.
Required material for applying adhesive to the belt
If you have never used the belt, clean it and remove any remaining dirt and dust.
Procedure Replacing Squeegee blade
S Mode Key Indication Operation Reference
1
Use the relevant control function to lower the rear part
of the tank.
2
Unlock the washing tank and remove it from the
machine.
3
Remove the tightening screw using an appropriate
size hex wrench.
4
Remove the worn squeegee blade and replace it with
a new one.
5 NOTE
Pay attention to the installation position of the
squeegee blade. The correct installation location is
shown in the following
Incorrect installation entails machine malfunction or
damage to components.
Installation of squeegee blade
6
Adjustment of squeegee blades then tighten the
screws once the correct position is reached
End of procedure
Table Feature Data
► Neutral base for adhesion
Unilevel ML ATR1948 Fortex S.p.A.
1 [Kg]
► Resin adhesive
Atrafix ML/K ATR1947 Fortex S.p.A
1.5 [Kg]
► Alcohol 100 [°]
► Adhesive paper tape 25 [mm]
► Solvent (for cleaning) Persolvan NV Villa I.C.
►
PET film for removing the bar after applying the
lining agent
Width: 60 [mm]
Length: 1650 [mm]
Thickness: 1 [mm]
Squeegee blade
installed correctly Squeegee blade
not installed
correctly