MIMAKI Kebab MKII, Руководство по эксплуатации

Страница: 33 / 56

Use the work holder
33
Use the work holder
The work holder can curb the horizontal shifting of the work during rotation and reduce the misalignment of drawing
that happens while drawing several times.
1
Loosen the screw of the left work
holder, and move it to the position
where it does not collide with the work
to be set.
2
Lightly loosen the screws (2 pieces)
retaining the right work holder.
3
Place the work near the right work
holder.
• After this, make sure that the work and work holder are
placed a little away from each other to adjust the right work
holder.
4
Move the ball part of the work holder on the right work holder so that
it lines up with the flat part of the side of the work.
• When lining it up with the side that is uneven, it may affect drawing; try to line it up with the part that is as flat
as possible.
• You can use the work holder for the work with a large diameter.
• When drawing the work with a small diameter, remove the work holder.
• You may not be able to use the work holder even for the work with a large diameter, depending on
the shape of work.
Screw
Screw
Work
Ball part to line up
with the work