MIMAKI Kebab MKII, Руководство по эксплуатации

Страница: 29 / 56

Installation of Kebab MkII system
29
Remove the Kebab MkII L system from UJF-7151 plus series
When removing Kebab MkII L system, follow the procedures below:
1
Press the key in the local mode.
2
Press the key in the [MACHINE SETUP]
page.
3
Press to select [SET OPTION JIG].
4
Press the key.
• The table goes down.
5
Remove the option relay cable from the
printer main unit.
6
Remove the option relay cable from the
rear surface of Kebab MkII system.
• When you press the key, “COMPLETED [ent]” is displayed on the screen. Do not
press the key until the work up to the Step 6 has been completed. If you press the
key before the replacing work has been completed, printer starts Kebab MkII L
system automatic recognition operation.
M E N U 1 / 3
WO R K S E T >
MENU
M E N U 2 / 3
M A C H I N E S E T U P >
ENTER
M A C H I N E S E T U P 2 / 2
S E T O P T I O N J I G >
S E T O P T I O N J I G
C OM P L E T E D
: e n t
ENTER
ENTER
ENTER
ENTER
Option relay cable
Option relay cable